Brocade常用命令

一般檢查Command
show flash：查看交換機記憶體中的memory images版本
show version：Software version, uptime, and last reload
show module：顯示交換機上的所有模組類型及工作狀態
show chassis：顯示Swtich的MAC address、電源、溫度及風扇的工作狀態
show statistic：查看埠的流量狀態
show interface brief：Interface status
show vlan：查看VLAN設定狀況
show telnet：IP address of active telnet session
show trunk：Configured and active trunk groups
show tech-support： Details for assistance in troubleshooting when working with Support
(批次處理命令show configuration、show version、show interface、show statistics、show
logging、dm statistics、dm save_area)

Brocade Switch：Recovering Passwords

1. Reload the switch
The switch must be reloaded. If you cannot log in to issue the “reload”command, you must power off the switch, and power it back on.
2. Enter Boot-Monitor mode by pressing the “b” key when prompted. You must press the “b” key within two seconds of the switch receiving power.
You should see a prompt that looks like this:
BOOT MONITOR>